Acronova XB53 Series - Manual (Page 17)

Version V1.2 Operation Manual, Xymba XB43/53
© 2008, Acronova Technology, Inc. 17
B
EFORE
G
ETTING
S
TARTED
Tips for Handling Optical Discs
Never touch the printable or data surface of the disc, as it may
decrease quality and disc lifespan. Refer to the arrows on the
illustration to the right, Always handle discs from the outer edge or the
center hole.
What You Need to Start a Disc Publishing Session
The Xymba XB43/53 is a PC-connected publisher, which requires a
USB connection to a host computer. You will need a computer with
the minimum system requirements and compatible software to start a
disc publishing session.
Important Tips for Loading Discs to Xymba
When the disc loader is empty, do not attempt to
load many discs at once.
First, carefully load only one disc into the disc
loader and assure it is firmly resting on the three
wheels seen in the illustration to the right. You
may then gradually load additional discs on top of
the first disc, until the loader is full.
Xymba processes discs in a First In, First Out (FIFO)
sequence. During a duplication session, if a disc
refill is required, before the loader becomes empty,
gently load additional discs.
Finish Disc Bin is Full or Out of Position
When the Finish Disc Bin or the Output Ram is out of position, the LED
indicator will show an error. At the same time, Xymba will signal the
software to pause the disc session immediately after the active disc
has completed writing. Depending on how the software is programmed,
it may also alert the user of an error.
Once the Finish Disc Bin is full, Xymba will immediately pause the
duplication session including any disc in the process of unloading.
The LED indicator status will show an error. To resume the session,
clear the Finish Disc Bin, return it to position and return to the software
to continue operation.