Acronova XB53 Series - Manual (Page 18)

Operation Manual, Xymba XB43/53 Version V1.2
18 © 2008, Acronova Technology, Inc.
LightScribe Labeling Operation
If you have purchased the LightScribe-enabled version of Xymba, you
may automatically label a stack of LightScribe discs. Follow the steps
below to start a LightScribe labeling session:
1) Place a stack of LightScribe discs label side down in the disc
loader. Make sure that the LightScribe label side is facing
downward.
2) Run the LightScribe-enabled application software and follow the
instructions to LightScribe label the discs.
Turning Xymba On
Make sure that Xymba’s device driver has been successfully installed
as previously explained.
Follow the steps below to get your Xymba ready:
1) Connect the power cord to Xymba and a wall outlet.
2) Turn Xymba’s power switch to the On position.
3) Connect the USB cable to both Xymba and your PC.
Xymba will enter the initialization process and will remove any discs
inside the optical recorder. Be patient until the initialization process
has completed.
When initialization is complete, you will see the “ready” indicator light up
signaling that Xymba is ready for a disc operation
Turning Xymba Off
To turn Xymba off, turn the power switch to the Off position. In case
there is a session underway, abort or wait until it has completed.
Although it is fine to leave the power cord plugged in, it is
recommended that you unplug the cord for increased safety when
Xymba is not used for extended periods of time.