Acura 2005 NSX - Owner's Manual - Manual (Page 149)

Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
Open the engine compartment,
and remove the engine oil fill cap.
Remove the oil drain bolt and
washer from the bottom of the
engine. Drain the oil into an
appropriate container. Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Install a new oil filter according to
the instructions that come with it.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to :
Install the engine oil fill cap. Start
the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
Make sure to clean off any dirt
and dust on the connecting
surface of a new oil filter.
2. 3.
4.
5.
6.
7.
8.
CONTINUED
Changing the Oil and Filter
Ma
int
e
na
nce
147
WASHER OIL DRAIN BOLT OIL FILTER
33 lbf·ft (45 N·m , 4.6 kgf·m)
5.3 US qt (5.0 )
Main Menu Table of Contents