AERCO KC1000 Water Heater July 2011 - Manual (Page 9)

INSTALLATION
2-1
SECTION 2 - INSTALLATION
2.1 RECEIVING THE UNIT
Each KC1000 Heater is shipped as a single
crated unit. The crated shipping weight is
approximately 1500 lb. and must be moved with
the proper rigging equipment for safety and to
avoid damage. The unit should be completely
inspected at the time of receipt from the carrier
before the bill of lading is signed. Each unit has
Tip-N-Tell indicator on the outside of the crate.
This indicates if the unit has been turned on its
side. If the Tip-N-Tell indicator is tripped, do not
sign for the shipment. Note the information on
the carrier’s paperwork and request a freight
claim and inspection by a claims adjuster before
proceeding. Any other visual damage to the
packaging materials should also be fully
explained to the delivering carrier.
2.2 UNPACKING
Carefully unpack the unit. Take care not to
damage the unit jacket when cutting away
packaging materials. A close inspection of the
unit should be made to determine if there has
been any damage incurred during shipment that
was not indicated by the Tip-N-Tell indicator.
The freight carrier should be notified
immediately if any damage is detected. The
following standard accessories are included with
each unit and are packed separately within the
unit’s packing container
• Spare Spark Igniter
• Spare Flame Detector
• Differential Regulator Spring:
P/N 122548 (Propane) or
P/N 124803 (Natural Gas)
• Manual 1-1/4" Gas Shutoff Valve
• Drain Valve Assembly
• ASME Pressure/Temperature
Relief Valve
• 2 Lifting Lugs
• Stainless Steel Condensate Cup
• Flue Clamps (2 Pieces)
• Shell Cap
• Wing Nut for Shell Cap
Optional accessories are also separately packed
within the unit’s packing container. Standard and
optional accessories shipped with the unit
should be identified and put in a safe place until
installation/use.
Figure 2.1 Heater Clearance