AirTurn PED - Manual (Page 7)

7
Note: Holding down the pedal in any MODE for more than
two seconds will repeat the key action until released.
CHANGING THE MODE
1. Turn on the PED.
2. Press and hold the MODE button. The red
LED will flash once per second from 1 to 6
flashes. The number of flashes corresponds
to the same MODE number. Be sure to count the
flashes.
3. Release the MODE button following the number of
flashes that reflects the desired MODE. The blue and
red LEDs will flash together the number of times
indicating which MODE has been set.
Example: To set MODE 2 hold the MODE button for 2
flashes of the red LED, release and both LEDS will flash
2 times to confirm the MODE 2 setting.
Note: Once the MODE has been set, it will remain the
same until it is changed following the above steps.
CONNECTING AND PAIRING
Once the PED is powered on, the blue LED will blink 2
times per second until pairing is started.