AirTurn PED - Manual (Page 9)

9
When the PED connects, the blue LED will blink 3 times per
second. Once paired, the blue LED will blink 1 time every
three seconds.
IMPORTANT: Do not try to connect in MODE 1 and any
other MODE at the same time. MODE 1 only works in PED-
APP-Direct MODE and MODES 2-6 only work when
connected directly through the operating system setup. You
must reset pairing to switch modes. If you choose MODE
conflicting apps in iOS, it is recommended to use MODE 2 for
both apps.
RESET PAIRING
Pairing must be reset whenever switching from one device to
another or when switching between MODES 1 and 2.
With the PED powered on, press and hold the power button
for six seconds. After two seconds, the PED will appear to
power down. Continue to hold the power button. At six
seconds both LEDs will blink three times. After the third
blink release the power button. The device has been reset.
Remove any old pairing from your host computer and then
turn on the PED to pair again with the desired host computer.
POWER CONSUMPTION
The PED uses an idle timeout function to conserve power.
After two hours of inactivity when powered on and connected,