ALTANA Mechanical Cupping Tester - Manual (Page 7)

8
English
3. Start-up
Unpacking:
Carefully open the packaging, remove the
smaller instruments before removing the
instrument itself. Make sure all components in
the component list are included.
Installation:
*Prior to installation, keep in mind that the
instrument must not be exposed to; excessive
heat or humidity, aggressive or corrosive
substances, flammable substances, or excessive
vibration
1. Ensure the instrument is situated on a firm,
hard level surface, strong enough to support
its weight without significant vibration with
adequate access to the front and sides.
2. Remove the battery cover from the rear
of the instrument by rotating ¼ turn
anticlockwise. Insert two alkaline D cells
with the positive contact pointing out of the
instrument (see symbol on battery holder
cover). Replace the cover. Use a coin or large
screwdriver for the cover slot.
3. Position the instrument with the LCD
towards the operator, leaving sufficient
room to operate the two handles without
obstruction.
4. Fix the instrument to the bench using the
mounting holes provided in the base plate
[6] (allowing enough room to replace the D
cells at the rear in the future).
Start-up