American Diagnostic Corporation (ADC) Diagnostix 2100 - Manual (Page 4)

Operating Instructions
Be sure to insert two AAA batteries before at- 1.
tempting to operate.
Clean inside surface of oximeter and patient’s 2.
finger with isopropyl alcohol before use.
Squeeze the end opposite the power switch be- 3.
tween the thumb and forefinger in order to open
the device (there is a textured surface on the bat-
tery cover side to facilitate grip). (Figure 2)
Insert patient’s finger, nail side up into the de- 4.
vice. (be sure to fully insert the patient’s finger so that the sensors are completely covered by the fin-
ger.) Index or middle finger is recommended.
Release the device allowing it to clamp down on the patient’s finger. 5.
Press the power switch on the front (top) panel to activate. 6.
Have patient keep still for optimal accuracy 7.
Depending upon environmental and patient conditions, the device will begin to display readings in 8.
about 4 seconds.
Note readings on the display. 9.
Remove the patient’s finger from the device by squeezing between forefinger and thumb as indicated 10.
in Figure 2.
The display will indicate finger out. 11.
The unit will power off approximately 10 seconds after the patient’s finger is removed from the device. 12.
Changing Oximeter Display Mode
There are six different display modes. The display modes alter the orientation of the display to facilitate
reading by the observer. Horizontal modes display the pulse wave form along with SPO2 and pulse rate
while vertical modes display a pulse rate bar graph along with the SPO2 and pulse rate readings.
To alter the display mode:
1. After the unit is powered on each brief press of the power switch will cycle through to the next
display mode in the sequence shown. Note: the default setting is display mode 1.
Display Mode Cycle
(Figure 2)
Handstand Horizontal
(4th click)
Pulse Tone Active
Alarm Tone Active
Normal Vertical
(5th click)
Pulse Tone Active
Alarm Tone Active
Handstand Vertical
(6th click)
Pulse Tone Active
Alarm Tone Active
Normal Horizontal
Wave Display
(Default Setting)
No Pulse Tone
Alarm Tone Active
Normal Horizontal
Wire Display
(2nd click)
Pulse Tone Active
Alarm Tone Active
Normal Horizontal
(3rd click)
Pulse Tone Active
Alarm Tone Active