American Diagnostic Corporation (ADC) ADview Modular Diagnostic Station - Manual (Page 65)

55
Recommended separation distances between portable and mobile RF communications equipment
and the ADview device
The ADview device is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the ADview device can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the ADview device as recommended below, according to the
maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
W
Separation distance according to frequency of transmitter
m
150 kHz to 80 MHz
d = [3.5/V
1
] √P
80 MHz to 800 MHz
d = [3.5/V
1
] √P
800MHz to 2.5GHz
d = [7/E
1
] √P
0.01 0.12 0.12 0.23
0.10 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d
in meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1—At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2—These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects, and people.
For units that are Bluetooth enabled, the following EU and FCC regulatory information
applies:
EU Regulatory Information
The transmitter module manufactured by Mitsumi and incorporated into the AdView BP module marked by
has been
approved in accordance with the R&TTE directive.
FCC Regulatory Information