Antari S-100X - Manual (Page 5)

5
bracket with the machine, the tightening screws are for adjusting the machine’s angle
when in the air.
4. Fill with ANTARI SL-5 Snow Liquid, ANTARI SL-5A Premium Snow Liquid or other
high-quality, water-based snow liquid recommended by your dealer. Any other types of
fluid can damage the unit. When filled, place cap back on liquid tank.
5. Firmly attach the 4-pin connector on the remote control cable to the proper input on the
rear of the machine.
Installation Note
1. The snow machine may be installed at floor level or suspended overhead. It is best
suggested to mount the machine up high. When mounting the unit overhead, please make
sure that it is secured with a safety bond looped through the safety ring. Whatever
installation method you choose, do not allow the unit to have more than a 15 degree angle
of inclination.
2. It is important that the snow does not shoot directly at anyone's face.
3. Always monitor tank fluid level during operation. Running a snow machine without fluid
can permanently damage the unit. If you experience low output, mechanical noise or no
output at all, unplug immediately. Check fluid level, the external fuse, remote connection,
and power from the wall. If all of the above appears to be fine, plug the unit in again. If
snow does not come out after holding the remote ON/OFF button down , check the hose
attached to the tank to make sure there is fluid going through the hose. If you are unable to
determine the cause of the problem, do not simply continue pushing the remote button, as
this may damage the unit. Return the machine to your Antari dealer.
Operation
1. Plug the power cable into a grounded electrical outlet.