Maintenance, Snow liquid, Technical specifications – Antari S-100X User Manual
Page 9
9
Maintenance
1. Do not allow the snow liquid to become contaminated. Always replace the caps on the
liquid container and the snow machine liquid tank immediately after filling.
2. Before storing away after each operation, rinse the system with pure water and let it pump
for at least 1or 2 minutes. This step helps to ensure a longer life span of the motor and the
nozzle.
3. It is strongly recommended to regularly clean
the dust/residue
around
the
machines' vent
holes (on both sides of the machine). Simply use a small brush, a toothbrush for example,
and gently brush in the direction from top to bottom. This step helps to ensure that minimal
debris will get into the machine or causes clogging.
Snow Liquid
Depending on the desired effect, use either ANTARI SL-5 Snow/Foam Liquid for normal snow
or ANTARI SL-5A Snow Liquid for fast-dissipating snow.
Technical Specifications
MODEL
S-100X & S-200X
Power Supply
100/120V AC, 230/240V AC, 50/60Hz
Motor
770W (min. output
), 1000W
(max. output)
Output Volume
180ml/min
Tank Capacity
5 liters
Fluid Consumption Rate
5.5 min
/liter (100
% output)
Weight
11 kg
Dimensions (LxWxH)
L505 W276 H280 mm
Remote Included
SC-2
10 Meter Remote Extension
EXT-6
DMX
On-board
Warm-up Time
N/A
Save these instructions.