2 switcher configuration, 3 connect mrm-602p and pc – Avlink MRM-602P User Manual
Page 28
M
M
M
R
R
R
M
M
M
-
-
-
6
6
6
0
0
0
2
2
2
P
P
P
27
7.1.3 Connect MRM-602P and PC
You must power off the MRM-602P Switcher. Then, connect the Switcher RS-232 port to
the PC RS-232 port with the bundled communication cable. And make sure the DIPs on
the rear panel are set to Master and RS-232. (Refer to the previous section
6.5.1
RS-232
)
7.2 Switcher Configuration
After finishing installation, click
to active AV Matrix Application. In the
“Options” window, select the connected PC Port number and Baud rate, and then click
“OK”.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below:
Figure 7-3《AV Matrix》Software Application Main Window