Connect Tech DFlex-4/104 - Manual (Page 57)

Chapter C: Appendix F - Factory Settings 4-7
DFlex-4/104 User's Manual, ver. 0.04
Appendix C: Factory Settings
Appendix C summarizes the following factory settings for the
DFlex-4/104 adapter.
I/O Port address setting
IRQ (Interrupt Request Line)
I/O/Status Port Address Setting
Switch block S1 sets the I/O and status port addresses for the
DFlex-4/104 adapter. Connect Tech ships the DFlex-4/104
adapter with S1 set for I/O port addresses 200, 208, 210, 218 hex
and the status port disabled. Figure 8 shows the location and
factory setting of this jumper block.
Figure 8: I/O/Status port address factory settings
Port address
switch block
9/ 2 10 11
4 5
SW
1
ON
1 2 3 6
Port address
switches
Status Port
switch