Avlink YX-1024 - Manual (Page 7)

YX-1024 Matrix Switching System—User Manual
6
cable.
The YX-1024 matrix “Audio Inputs” and “Audio Outputs” can be separately connected to
the audio signal connector of the video recorder and a multiplexer.
Connection Method: Use the RCA (often referred to as the lotus socket) connector for
connection. You are recommended to use the 14 x 18mm 4-hole RCA JAYK connector for
connection to input and output equipment. Connect the RCA video and audio connectors of the
signal source equipment output terminal to the same channel RCA connector of the YX matrix
input terminal, and also connect the RCA connectors of the YX-1024 matrix output terminal to
the RCA input connectors of the output equipment via a dedicated RCA signal cable.
NOTE: The RCA connectors at both ends of the various signal cables must correspond to
each other, otherwise loss of color reproduction or even no signal output could happen.
Advantage: The AV connectors have realized separate audio and video transmission,
thereby averted mixed audio/video interference to degrade graphics quality. The AV connectors
have now been extensively used in TV equipment.
5.0 YX Matrix Control Panel Operation
5.0.1 Installation
Before the installation, make sure the peripherals are turned off.
1. Connect the YX-1024 video input RCA connector with RCA Video male to male cable from
DVD players (source device).
2. Connect the YX-1024 audio input RCA connector with RCA audio cable from DVD players
(source device).
3. Connect the YX-1024 video output RCA connector with RCA Video male to male cable from
HDTV (target device).
4. Connect the YX-1024 audio output RCA connector with RCA audio cable from HDTV or
audio amplifier (target device).
5. Connect the power cord each side.
6. The power LEDs (green) will light constatly. If not, please go back to check step 5.
7. Turn on the DVD players and HDTV and audio amplifier.