AvMap Geosat 2C - Manual (Page 8)

28
VERY IMPORTANT!!!
When you switch On Geosat 2C a note for your safety will appear on the
display.
If you select YES you can use Geosat 2C in passenger mode and all the
functions are activated.
If you select NO you can use Geosat 2C in driver mode and a few
functions are not activated if the vehicle is moving.
TO CHANGE THE MODE YOU MUST SWITCH THE UNIT OFF, SWITCH IT
ON AGAIN AND THEN CHOOSE THE MODE YOU PREFER.
HOW TO PLAN A ROUTE
Press [PAGE] to switch On the unit and choose the mode you want to activate
(passenger or non passenger); now you are ready to navigate.
Pressing [FIND] you can make a research by nearest, by name, by latitude and
longitude or among your recently found destinations.
We will guide you through a research by name:
♦
Press [FIND].
♦
Using [CURSOR], select "ADDRESS..." and press [ENTER] to confirm.
♦
You can change the item highlighted with a broken line, using [CURSOR] to
select and press [ENTER] to confirm.
♦
To shift on the virtual keyboard use [CURSOR], to confirm a character press
[ENTER] (selecting EXT another keyboard containing stressed letters and sym-
bols is displayed, selecting it again you restore the common one) to confirm the
choice press [ENTER] on the virtual keyboard.
♦
After setting town, road and house number (if available) press [MENU].
♦
Select “Set destination on cursor and calculate” and confirm pressing [ENTER].
♦
You can choose to visualize a Map + Data Page or a Map + Manoeuvre Page.
NOTE about the suggested route
a. Do not rely only on the voice prompts because they could be incorrect or
late. Check the route on the screen and follow the directions displayed on
the map, read carefully point d.
b. It may happen that such directions as “Keep right” or “Turn right” cannot be
always followed, because of changes in the road. In this case follow the signs
on the road and remember the points a and d of these notes.
c. Pay much attention when turning roundabouts or passing through
crossroads because the voice guidance could not be easy to follow.
Remember the points a and d of these notes.
d. WARNING: do not become distracted to the exclusion of safe driving
practices; do not look at the screen because it might be dangerous. It is
unsafe to operate the controls of the navigator while driving.
Use [+] key to show the map area with more detail, especially in towns with many
streets.
Pressing [FIND] you can also look for a destination: by nearness to your position,
by latitude or longitude or among your latest researches.
HOW TO CREATE A MARK
With Geosat 2C you can create and save many Marks (User Points), wherever you
are, you can enter your customers, your house or your favourite restaurant.
These Marks are easy to display, to change and to use as destinations.
♦
To create a Mark press [ENTER] and select the desired item.
♦
To change or delete a Mark move the arrow on it, press [ENTER] and select the
desired item.
♦
To use a Mark as a destination press [FIND] and select Mark.
User Manual