Chamberlain LIFTMASTER MUGAPLM - Manual (Page 4)

4
Step 1: On ONE repeater, set Dipswitch #1 to ON. All
other Dipswitches should remain OFF.
Step 2: Press Learn button on both Repeaters (within
5 seconds of each other). LED will light.
Step 3: Within 20 seconds, enter Master PIN Number
on MUGAPLM.
Step 4: Press “05”.
Step 5: Followed by (00-63)
Step 6: Then press the Call button. The LEDs on the
Repeaters will flash 3 times indicating programming is
successful. Allow MUGAPLM 30 seconds to time-out
of Learn Mode, or press the “ * ” to end Learn Mode
before proceeding.
Second Repeater Set
Step 1: On ONE repeater, set Dipswitch #1 to ON. All
other Dipswitches should remain OFF.
Step 2: Press Learn button on both Repeaters (within
5 seconds of each other). LED will light.
Step 3: Press Learn button on ONE of the first set of
Repeaters. LED will light.
Step 4: The LED’s on the second set of Repeaters
will flash three times indicating programming is
successful.
NOTE: If adding Repeaters to existing network, all
accessories that have been programmed to the
MUGAPLM will have to be cleared and
reprogrammed.
When using the OTIU, OTIU-EX, MUOTIU and
MUOTIU-EX only one set of Repeaters may be used.
When using an Intercom two sets of Repeaters may
be used.
For complete installation and operating instructions
refer to Repeater manual.
Repeater Set
Each numbered button on a remote control
transmitter must be programmed separately as each
button controls one of four GCU’s.
Step 1: Enter Master PIN Number on MUGAPLM.
Step 2: Press “8”.
Step 3: Then enter the Gate Control Unit (GCU)
Identity (1-4). If there is only one GCU, enter “1”.
MUGAPLM will beep.
Step 4: Press and hold the remote control transmitter
button that is to be used for that GCU. MUGAPLM will
beep twice indicating programming is successful.
Remote Control Transmitter