Bullet Tools 920 - Manual (Page 4)

4
Back Stroke Stop Cam Shaft
Han
dle
Asse
mbl
y
set up
3. attach taBle
a. Attach table to base starting with
front, start screws with hand, using Item D
machine screws.
B. Attach back of table to tail using Item E
self tapping screws.
5. place the Fence
Insert fence into one of the six hole sets on
the table: there are two 90º and four 45º
locations. The fence is friction fit (requires
effort to insert or remove).
6. align laser
To adjust laser line projection angle, turn
on laser by pushing the red button. Loosen
(but do not remove) laser attachment screw
(M4x12 PHP) by 4 to 5 full turns. Firmly press
on sides of laser ‘barrel’ with two fingers of
each hand. Rotate laser ‘barrel’ until desired
alignment is achieved. Tighten the laser
attachment screw snugly.
3 3B 3a
4. attach handle:
insert handle into cam shaft.
Note: Backstroke Stop must be on top!
Tighten Item F Bolt (pre-installed in cam shaft)
with 10mm hex wrench Item G (Included).
Note: Do not remove plastic tie and orange tag until handle is bolted in place.
Handle under extreme pressure - do not allow to slam back!
!
5
4
Screw
ON Button 6
M16 x 50 Bolt