Burris Veracity - Manual (Page 4)

Windage/Elevation Adjustment for Multi-Turn
Target Knobs with Zero Click Stop
– Applies to 4x-20x and 5x-25x models –
The Multi-Turn Target windage and elevation knobs
are designed for precise adjustment and feature Zero
Click Stop. The click value for each knob is indicated
on the dial. For shooting at extreme distances, the
elevation knob offers up to 15 MOA/rotation with multiple
revolutions of adjustment.
Use the following procedure when sighting-in if you
need additional downward point of impact adjustment
past the Zero Click Stop:
1) Turn the elevation adjust-
ment knob clockwise to “0”.
2) Use the 2mm hex wrench
supplied with the scope to
loosen the 2 set screws on
the elevation adjustment
knob located just under
the top of the knob.
3) Pull up slightly on the
adjustment knob to the
second white hash mark
on the turret. Turn the knob
clockwise slightly more
(maybe 2-5 more clicks)
than the number of MOA
needed to achieve zero.
4) Once the elevation adjust-
ment is complete, loosen
the two set screws and
reset the knob to “0”. With
the screws loose, push
down firmly on the knob
until it is fully seated on the
turret base and then
retighten the set screws.
NOTE: When retightening set screws on elevation knob,
maintain pressure on the top of cap to ensure proper
seating of adjustment dial.
3