Burris Veracity - Manual (Page 6)

5
Mounting the Scope
Veracity riflescopes require 30mm rings. We recommend
using high-quality rings and bases, like the Burris
Signature Rings or Xtreme Tactical Rings and Xtreme
Tactical Bases. Quality components ensure that your
scope will remain safely and securely mounted, and
will provide the maximum accuracy. Use care when
mounting your scope as damage caused by improper
mounting is not covered by the Burris Forever
Warranty.
Care & Maintenance
The Veracity riflescope is fully waterproof and fog-
proof. In the event that the lenses are subjected to
dust, dirt or mud, follow these steps to clean and
protect the lens surface. Failure to remove grit before
final cleaning is sure to damage lens coatings.
Coarse dirt/debris must be removed from the lens
surface. The most convenient way to clean a lens
surface is to use a Lens Pen. Position the scope so
particles will fall away from the lens, and then use the
Lens Pen or soft brush to gently whisk away the
debris while blowing on the lens to dislodge the
particles. For heavy dirt, like dried mud, use a spray of
clean water or lens cleaning fluid to remove the dirt.
Your Burris riflescope will provide reliable performance
given reasonable care and treatment. All moving
assemblies are permanently lubricated. Only occasional
cleaning of the outside of the scope and the exterior
lenses is required. Never disassemble your scope.
Disassembly by anyone other than our factory will void
the warranty. If you have any other problems with
your riflescope, return it to the Burris factory for repair.