C&D Technologies 41-6976 RB VRLA Rack - Manual (Page 9)

Page 9 of 9
VRLA
R-9. Install hold down rod
Attach a rod to each end support frame starting with the lowest tier -
Mounting Hardware – torque to 46 ft lbs
13 ¾” long threaded rod 3/8” – 16
3.8” hex nut
3/8” flat washer
end support frame
3/8” flat washer
3/8” – 16 hex nut
Then secure the rod to the hold down strut
Mounting hardware – ¼ turn past finger tight
Square washer
3/8” wing nut – DO NOT OVER TORQUE wing nut
R-10. Install Top Cover
Mounting Hardware starting at outer cover surface– torque to 46 ft lbs
• ¾” L Carriage bolt #3/8 – 16
(Top cover)
• 3/8 Flat washer
• 3/8 Lock washer
• 3/8 – 16 Hex nut
R-11. Verify proper torque of all hardware
REMEMBER, the wing nut on top of the hold down strut is only tightened ¼ turn past finger tight.
Any data, descriptions or specifications presented herein are subject to revision by C&D
Technologies, Inc. without notice. While such information is believed to be accurate as indicated
herein, C&D Technologies, Inc. makes no warranty and hereby disclaims all warranties, express
or implied, with regard to the accuracy or completeness of such information. Further, because
the product(s) featured herein may be used under conditions beyond its control, C&D
Technologies, Inc. hereby disclaims all warranties, either express or implied, concerning the
fitness or suitability of such product(s) for any particular use or in any specific application or
arising from any course of dealing or usage of trade. The user is solely responsible for
determining the suitability of the product(s) featured herein for user’s intended purpose and in
user’s specific application.
Copyright 2007 C&D TECHNOLOGIES, INC. Printed in U.S.A. 41-6976
1400 Union Meeting Road
P.O. Box 3053 • Blue Bell, PA 19422-0858
(215) 619-2700 • Fax (215) 619-7899 • (800) 543-8630
[email protected]
www.cdtechno.com
Hold down rod with square washer & wing nut
Hold down strut assembly
Battery Support Rail End Support Frame
Battery
RB Rack - Front View
Cover - Side View Cover - Top View