Cadillac 2004 CTS - Manual (Page 117)

Reprogramming a Single HomeLink ®
Button
To program a device to HomeLink ® using a HomeLink ®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink ® button.
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink ®
button, proceed with Step 2 under “Programming
HomeLink
® .”
Resetting Defaults
To reset HomeLink ® to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink ®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink ® at
1-800-355-3515, or on the internet at www.homelink.com.
2-51