CAMCORP SWF with Internally Mounted Fan - Manual (Page 31)

6
© Emerson Power Transmission Manufacturing, L.P. or affiliates 2003. All Rights Reserved.
1/6 OF FACEWIDTH
CLEAR ON
ENTERING SIDE
1/3 1/3 1/3
IDEAL
RUNS FROM
CENTER TOWARDS
LEAVING EDGE
MOVE GEAR
RUNS TO
ENTERING EDGE
DOES NOT ENTER
CENTER THIRD
MOVE GEAR
4. Seals - To reassemble seals to unit, see Parts Service Steps on
Page 3.
5. Motorized Coupling Adapter
Reassemble using the original dimensions determined under "General
Instructions" on Page 2.
6. Final Inspection
A. Turn the gear train by hand as a final check.
B. Re-install reducer and accessories.
C. Fill reducer with the recommended oil to the appropriate level.
See the installation instructions supplied with the
reducer.
D. Spin test for three minutes and check for noise, leakage or rapid
temperature rise.
PREVENTATIVE MAINTENANCE
1. After first week, check all external capscrews and plugs for tightness.
2. Periodically, check oil level when gears are at rest. Add oil if needed. Do not fill above the recommended level because
leakage and overheating may result.
Fig. 6a: Entering and Leaving Sides
Fig. 6b: ACCEPTABLE
Fig. 6c: UNACCEPTABLE
Emerson Power Transmission
P.O. Box 687
Maysville, Kentucky 41056
TEL: 800-626-2093
Printed in U.S.A.