Carl Goldberg GBGA1042 - Manual (Page 3)

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 5 CHANNEL RADIO WITH 6 MICRO SER-
VOS. (WE USED 6 CHANNEL FUTABA
RADIO WITH S3108 SERVOS AND GREAT
PLANES ELECTRICFLY RECEIVER W/O
SPEED CONTROL)
2 12” SERVO EXTENSIONS
1 ELECTRONIC SPEED CONTROL (WE
USED A CASTLE CREATIONS PHOENIX
25 BRUSHLESS SPEED CONTROL)
1 3 CELL LI-PO BATTERY (GREAT PLANES
ELECTRICFLY 1500)
1 ULTRAFLY BRUSHLESS MOTOR A/30/29
WITH 3.89 GEAR RATIO
1 GREAT PLANES ELECTRIFLY PROP
ADAPTER 3MM APC LONG
1 APC PROPELLER 9 X4.7 SLO FLYER
1 CA ACCELERATOR
1 1 OZ. BOTTLE CA MEDIUM GLUE
1 1/2 OZ. BOTTLE CA THIN GLUE
1 5 MINUET EPOXY
1 1/4” FOAM RUBBER
1 #2 X 1/4” SHEET METAL SCREW FOR
MOTOR(MIGHT BE REQUIRED FOR SOME
MOTOR INSTALLATIONS)
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X48")
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
24” RULER
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
5 FT. LENGTH OF STRING
Caution:
Before starting, care-
fully go over all high
stress areas (Wing
bolt mounting blocks,
Firewall, landing gear
blocks, fuselage form-
ers, etc.) with an
epoxy or wood glue to
confirm all areas are
well glued.
We will not warranty
any of these parts.