Carl Goldberg GBGA1085 - Manual (Page 14)

14
ENGINE INSTALLATION
1. C
OLLECT THE FOLLOWING PARTS
(1)
ENGINE
(4) #6
X
3/4
SHEET METAL SCREWS
(3)
MOTOR MOUNT PLATES
(1)
SPINNER
8. Slide the nosegear wire into the hole in the EZ
connector, then re-install the rudder pushrod
in the outer hole.
Re-mount the servo arm and center the servo
arm and the nosegear wheel.
When satisfied, tighten the set screw on the
EZ connector.
2. Find the right size motor mount for your
engine.
WE HAVE INCLUDED THREE DIFFERENT MOTOR MOUNT
PLATES IN THE
SKYLARK ARF.
TWO OF THE
PLATES WE HAVE CUT OUT FOR THE MOST POPULAR
ENGINES IN USE TODAY
.
WE HAVE ALSO GIVEN YOU A
THIRD MOUNT THAT YOU CAN CUT TO FIT YOUR
ENGINE
.
3. Once you have picked a motor mount then
place the mount into the front of the fuselage.
Make sure that the smaller side beam is on
the left side of the fuselage.
The motor mount should point a little to the
right about 2 degrees. Mark the top of the
plate.
Left side of the fuselage
Gap
4. Slide the engine into the motor mount and
through the front nose ring.
Open the spinner and place the spinner back
plate onto the engine. This will help to center
the front of the engine to the fuselage
Make sure that there is a clearance between
the spinner back plate and the front of the
fuselage .