Carl Goldberg GPMA1966 Tiger 2 ARF - Manual (Page 20)

20
3. Apply the instrument panel decal (see Apply the
Decals section). Use canopy glue to glue the canopy in
place as shown. Tape the canopy down and allow the glue
to dry overnight. The canopy can also be screwed into place
(additional screws not included).
4. Install the spinner backplate, propeller, prop washer,
prop nut, and spinner cone onto the engine crankshaft. The
spinner backplate (and propeller) may need to be drilled or
reamed larger to match the crankshaft diameter. Be sure to
balance your prop!
5. This completes the assembly of the Tiger 2 ARF!
APPLY THE DECALS
1. Use scissors or a sharp hobby knife to cut the decals from
the sheet.
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water—about one teaspoon of
soap per gallon of water. Submerse the decal in the soap and
water and peel off the paper backing. Note: Even though the
decals have a “sticky-back” and are not the water transfer
type, submersing them in soap & water allows accurate
positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding
the decal down, use a paper towel to wipe most of the
water away.
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
GET THE MODEL READY TO FLY
INSTALL AND OPERATE THE MOTOR BATTERY
(BRUSHLESS ONLY)
IMPORTANT: If using multiple battery packs that are connected
with an adapter, never charge the batteries together through
the adapter. Always charge each battery pack separately.
Charge the batteries, then read the following precautions on
how to connect multiple packs for fl ying the model:
BATTERY PRECAUTIONS:
There are two ways to connect multiple battery packs: In
Series and in Parallel.
OKAY
❏ 1. Connecting batteries in “Series” means to connect
the +’s to the –’s and the –’s to the +’s. This combines the
batteries’ Voltages, but the capacity remains the same.