Carl Goldberg GBGA1053 User Manual
Page 10
3.
Locate the pre-cut stab cutout by feeling
along the fuse side in the area where the
stab should go.
Remove the covering over the stab slot on
both sides of the fuselage.
4.
Mark the center of the stab on both the trail-
ing and leading edge.
5.
Slide the stab into the back of the fuselage,
using the center marks as a guide. Measure
the stab, as shown, to make sure it is prop-
erly centered.
NOTE: It is also possible to see the centermarks
through the fin cutout.
6.
Turn the fuse around, and determine the
vertical centerline of the fuse top front.
Measure to the center point on the top of the
fuselage. DO NOT CENTER ON THE FIRE-
WALL THRUST LINE.
7.
Place a pushpin on the center mark and tie
a string around the pushpin.
8.
Stretch the string back until it touches the
outer tip of the stabilizer leading edge. Mark
the string and then measure back to the
other outer L.E. tip, making sure the distance
is the same.
10