Carl Goldberg GBGA1053 - Manual (Page 8)

1. Collect the following parts.
(1) Fuselage
(1) Servo tray
(2) Front cabane doubler
(2) Cabanes
(2) Cross brace
(4) 4-40 x 1/2” Socket head screw
(4) 4-40 x 3/8” Socket head screw
(4) #4 x 7/16” washer
(4) #4 washer (smaller)
(8) 4-40 lock nut
2. Being careful to align the holes and the
servo cutouts, CA glue the servo tray dou-
bler into the fuselage.
4. Beginning at the front of the fuselage, make
a mark at 5” and at 9-3/4”. This will help
locate the pre-cut cabane slots on the
curved top of the fuse, behind the firewall.
5. Using a hobby knife, make a horizontal slit
from front to back, in the middle of the
cutout, as shown.
Slit all four cutouts in the same way.
FUSELAGE ASSEMBLY
Cabane Installation
3. Glue the front cabane doublers over the
holes in front of the fuselage former. Again,
make sure the holes in both the doubler and
the fuselage are aligned.
6. Gently push one side of the cabane into the
front fuselage slot, until it falls inside.
7. Slip the other side of the cabane into the cut
on the opposite side of the fuselage.
8