Carl Goldberg GBGA1083 - Manual (Page 15)

15
Wild Stick .40
5. Locate one of the 2mm pushrods,
metal clevis, silicone clevis keeper,
and nylon swing in keeper. Make sure
the clevis is screwed on the pushrod
with about 1/16” of threads showing
on the inside of the clevis. Install the
clevis on the control horn. make
sure the servo is centered and the
aileron is in neutral. Mark the loca-
tion of the wire where it crosses the
control horn and bend at a 90 degree
angle. Cut the angle off at 3/8”.
Install the pushrod in the control
horn and retain using the nylon
swing in keeper.
6. Install the rudder servo in the bot-
tom of the fuselage at the rear using
hardware supplied with radio.
7. Install the rudder pushrods the
same way we installed the aileron
pushrod. Locate two 2mm x 30cm
pushrods, install the clevises on the
horns, center the rudder and servo.
Mark the bend at the servo end and
bend 90 degrees. Cut off at 3/8”.
Install in servo arm and retain with
nylon swing in keeper.