Carl Goldberg GBGA1083 - Manual (Page 17)

17
Wild Stick .40
12. Slide the 5mm plastic tube on the
throttle pushrod until it extends
1/4” through the firewall. Install
the pushrod connector on the servo.
Open the throttle full and set the
throttle servo to full. Tighten the
set screw on the pushrod connector
onto the pushrod. Cut the pushrod
off about 1/4” pass the connector.
The throttle can be adjusted by loos-
ening the screw on the pushrod con-
nector if necessary.
nylon tube
13. Locate the 14” wooden dowel,
two 12” threaded rods with clevis,
one 6” piece of 2mm wire, and two
pieces of Shrink tubing.
14. Take the two pushrods and bend a
90 degree angle at 8-1/2” on one and
8-11/16” on the other. The difference
in length will make the ends even
after you install them in the holes in
the wooden dowel.
15. insert the ends of the pushrods in
the pre-drilled holes in the dowel
with the short one in the rear most
hole.
16. Glue in place with CA glue then
install the shrink tubing and shrink it
tight.
17. Bend the pushrods out until the
clevises are about 2-1/2” apart.