Carl Goldberg GBGA1043 - Manual (Page 13)

13
2. Thread the cable through one of the swages
then through the hole in the end of the thread-
ed coupler and back through the swage.
3. Loop the cable back through the swage then
crimp the swage with a pair of pliers.
4. Screw the threaded coupler with cable
attached into the nylon clevis assembly on the
rudder horn.
5. Thread the cable into the access hole in the
side of the fuselage.
Repeat for the other cable.
rudder cable access hole
threaded coupler with cable
6. Take the other two threaded couplers and
install a nut and clevis on each.
7. Install the two clevis assemblies on a double
control arm.
Center the servo and attach the control arm.
Tape the rudder in place centered.