Carl Goldberg GBGA1043 - Manual (Page 16)

16
3. Mount the servo to the mount using the hard-
ware supplied with the servo.
4. The throttle servo mount can now be mounted
in a position to match your engine.
5. Locate the e-z pushrod connector and install on
your servo arm.
6. Thread the 2-56 clevis on the pushrod and
insert into the plastic tube. Connect the clevis
to the throttle arm on the motor. Connect the
other end of the pushrod to the e-z connector
on the throttle servo and adjust.
2. Assemble the throttle servo mount by gluing
the 3/8” square rails in the corners of the 1/8”
plate and gluing the triangle gussets under the
rails.