Assembly, Caution, Remove the generator from the shipping carton – Champion Power Equipment 42432 User Manual
Page 11: Add engine oil, Attaching the engine vibration mounts, Attaching the alternator vibration mounts
REV 42432-20121015
8
42432
ENGLISH
ASSEMBLy
Your generator requires some assembly . This unit ships
from our factory without oil . It must be properly serviced
with fuel and oil before operation .
If you have any questions regarding the assembly of your
generator, call our help line at 1-877-338-0999 . Please
have your serial number and model number available .
Remove the Generator from the Shipping Carton
1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the
generator .
3 . Carefully cut each corner of the box from top to
bottom . Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg .
1 . Place the generator on a flat, level surface .
2 . Remove oil fill cap/dipstick to add oil .
3 . Add 0 .42 qt . (0 .4 L) of oil and replace oil fill cap/
dipstick . Once oil has been added, a visual check
should show oil about 1-2 threads from running out of
the fill hole .
4 . Check engine oil level daily and add as needed .
The recommended oil type is 10W-30 automotive oil .
NOTE
Add Engine Oil
DO NOT attempt to crank or start the engine before it
has been properly filled with the recommended type and
amount of oil . Damage to the generator as a result of
failure to follow these instructions will void your warranty .
CAuTION
The engine is equipped with a low-oil-shutoff and will
stop when the oil level in the crankcase falls below the
threshold level .
CAuTION
Check oil often during the break-in period . Refer to the
Maintenance section for recommended service intervals .
NOTE
The generator rotor has a sealed, pre-lubricated ball
bearing that requires no additional lubrication for the life
of the bearing .
NOTE
Attaching the Engine vibration Mounts
1 . Thread the vibration mount bolt through the frame
(engine side) .
2 . Firmly secure the bolt to the frame with the M8 nut .
Tighten . DO NOT over tighten .
3 . Repeat steps 1-2 for the remaining mount (2 total) .
Attaching the Alternator vibration Mounts
1 . Thread the flange bolt (M8x20) through the vibration
mount and then through the frame (alternator side) .
2 . Firmly secure the bolt to the frame with the M8 nut .
Tighten . DO NOT over tighten .
3 . Repeat steps 1-2 for the remaining mount (2 total) .