Champion Power Equipment 92750 - Manual (Page 19)

REV 92750-20131216
16
92750 ENGLISH
MAINTENANCE AND STORAGE
Maintenance Schedule
Follow the service intervals indicated in the schedule
below . Service your log splitter more frequently when
operating in adverse conditions . Contact our help line at
1-877-338-0999 to locate the nearest Champion Power
Equipment authorized service dealer for your log splitter
or engine maintenance needs .
Log Splitter Maintenance
Make certain that the log splitter is kept clean and stored
properly . Only operate the unit on a flat, level surface in
a clean, dry operating environment . DO NOT expose the
unit to extreme conditions, excessive dust, dirt, moisture
or corrosive vapours .
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed .
Clean spark arrester every 100 hours .
Check and tighten all bolts and nuts before operating the
log splitter .
*To be performed by knowledgeable, experienced owners, any small
engine repair shop, or Champion Power Equipment certified dealers .
Every time of use or daily
Check engine and hydraulic oil levels
Clean around air intake and muffler
Check air filter
First 5 Hours
Change engine oil
Every 25 Hours or per 1 month
Change engine oil
Clean air filter
Every 50 hours or per 6 months
Clean and adjust spark plug
Check cooling fan
Every 100 hours or per 1 year
Clean spark arrester (optional)
Check/adjust maximum load speed*
Check/adjust valve clearance*
Clean fuel tank and filter*
Change hydraulic oil
Change hydraulic oil filter
Every year
Inspect wheel bearings and repack bearing grease
as needed
Every 200 hours
Clean combustion chamber
Every 200 hours or per 2 years
Check/replace fuel line
Change spark plug
Never store the log splitter inside next to appliances where
there is a source of heat or open flame, spark or pilot light
because they can ignite gasoline vapors .
DO NOT store a log splitter near fertilizer or any corrosive
material .
Even with an empty gas tank, gasoline vapors could ignite .
WARNING
Storage
Refer to the Maintenance section for proper cleaning
instructions .
Log Splitter Storage
1 . The log splitter needs to be cool for at least 5
minutes before storing .
2 . Clean the log splitter before storage according to the
Maintenance section .
3 . Retract the wedge to protect the rod from corrosion .
4 . Wipe the beam and wedge with an oily rag to prevent
rust and corrosion .
Engine Stored for Less than 30 Days
1 . Allow the engine to cool completely before storage .
2 . Clean engine according to the Maintenance section .
3 . To extend the fuel storage life add a properly
formulated fuel stabilizer to the tank .
4 . Ensure the fuel valve is in the “OFF” position .
Engines Stored for Over 30 Days
1 . Add a properly formulated fuel stabilizer to the tank .
2 . Run the engine for a few minutes so the treated fuel
cycles through the fuel system and carburetor .
3 . Turn the fuel valve to the “Off” position .
4 . Let the engine run until fuel starvation has stopped
the engine . This usually takes a few minutes .
5 . The engine needs to cool completely before cleaning
and storage .
6 . Clean the engine according to the maintenance section .
7 . Change the oil .
8 . Remove the spark plug and pour about 1⁄2 ounce
(14 .8 mL) of oil into the cylinder . Using the Recoil,
crank the engine slowly to distribute the oil and
lubricate the cylinder .
9 . Reattach the spark plug .