Troubleshooting, For further technical support – Champion Power Equipment 10020 User Manual
Page 16
13
REV 10020-20131126
ENGLISH
10020
TroublesHooTING
Problem
Cause
Solution
Motor does not turn on
Loose battery cable connections Tighten nuts on all cable connections
Defective Switch Assembly
Replace Switch Assembly
Defective motor
Check for voltage at armature port with Switch
pressed . If voltage is present, Replace motor
Water has entered motor
Allow to drain and dry . Run in short bursts without
load until completely dry
Motor runs but Cable
drum does not turn
Clutch not engaged
Move Clutch to the "In" position . If problem persists,
a qualified technician needs to check and repair
Motor runs slowly or
without normal power
Insufficient current or voltage
The battery is weak, recharge . Run winch with vehicle
motor running (Battery should have a strong charge)
Loose or corroded battery cable
connections .
Clean, Tighten, or replace
Motor overheating
winch running time too long
Allow winch to cool down periodically
Motor runs in one
direction only
Defective Switch Assembly
Replace Switch Assembly
for further technical support:
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@championpowerequipment .com