CHEVROLET 2011 Traverse - Manual (Page 138)

Black plate (8,1) Chevrolet Traverse Owner Manual - 2011
5-8 Instruments and Controls
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone is
set to the variance zone in which
the vehicle is located. See
“Compass Variance (Zone)
Procedure” earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information
button until PRESS V TO
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE
for a few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.
Clock
To adjust the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN, then
press
O
, to turn the radio on.
2. Press
G
to display HR, MIN,
MM, DD, YYYY (hour, minute,
month, day, and year).
3. Press the pushbutton located
under any one of the labels to be
changed.
4. To increase the time or date, do
one of the following:
. Press the pushbutton below
the selected label.
. Press
¨
SEEK.
. Press \ FWD.
. Turn
f
clockwise.
5. To decrease the time or date, do
one of the following:
. Press
©
SEEK.
. Press
s
REV.
. Turn f counter‐clockwise.