CHEVROLET 2010 Camaro - Manual (Page 215)

Setting Cruise Control
{ WARNING
If you leave your cruise control
on when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
You could be startled and even
lose control. Keep the cruise
control switch off until you want
to use cruise control.
The cruise control buttons are
located on the outboard side of the
steering wheel.
5 (On/Off): Press to turn the
cruise control system on and off.
An indicator light comes on in
the instrument panel cluster.
\ (Cancel): Press to cancel cruise
control without erasing the set
speed from memory.
RES/+ (Resume/Accel): Move
the thumbwheel up to resume a set
speed or to accelerate to a higher
speed.
SET/
−
(Set/Coast): Move the
thumbwheel down to set a speed
or to decrease the speed.
To set a speed:
1. Press 5 to turn cruise control
on. The indicator light in the
instrument panel cluster
comes on.
2. Get to the speed desired.
3. Press the thumbwheel toward
SET/
−
and release it.
4. Take your foot off the accelerator
pedal.
When the brakes are applied, the
cruise control shuts off.
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
are applied, the cruise control is
disengaged. The indicator light
on the instrument panel cluster goes
out when the cruise is no longer
engaged. To return to the previously
set speed, press the thumbwheel
up toward RES/+ briefly when the
vehicle has reached a speed of
about 40 km/h (25 mph) or more.
This accelerates the vehicle to the
previously selected speed.
Driving and Operating 8-39