Citizen Systems iDP-3550 - Manual (Page 26)

4.6 Inserting the Paper
1. Cut the end of the paper roll at close to a right angle.
CAUTION : • Be sure to use the specified paper roll.
• Use of unspecified paper may adversely affect print quality, printer service life, and so on.
• Do not insert a frayed or bent end of paper into the printer.
2. Check the winding direction of the paper roll. (See the figure on the next page.)
3. Hold the paper holder open and insert the paper roll so that it is securely supported by the paper holder.
4. Turn on the printer.
5. Insert the end of the paper roll straight into the paper inlet slot (Indicated by the arrow).
6. The paper is automatically fed in and comes out the paper outlet of the printer (Paper outlet of the auto
cutter for the iDP-3551).
You can cut the surplus paper using the tear bar.
CAUTION : • If the paper is slack, rewind it, to remove the slack.
• While printing, do not hold the paper. This can cause a paper jam.
• When closing the auto cutter, do so gently not to give a shock.
Paper Inlet Slot