CLIFFORD AvantGuard 5.1 - Manual (Page 26)

23 © 2 0 0 6 d i re c t e d e l e c t ro n i c s — a l l r i g h t s re s e r v e d
manual programming instructions
Be sure to document changes by taking note of all feature changes
made in programming mode.
To enter the User Selectable Features programming:
1. Ignition on - Turn the ignition to the run position or start the
engine.
2. Enter PIN - Enter the factory preset PIN code 2 by pressing
on the PlainView 2 Valet switch twice, then once.
3. Hold/Chirp/Release - After entering the PIN code, press and
hold
until a chirp is heard and the LED turns on, then
release the button. You have now entered the feature selec-
tion position of the User Selectable Features grid.
4. Column select - Press the same number of times as the
desired column. After a pause the siren will chirp the same
number of times as the selected column for confirmation.
5. Feature select - Press the same number of times as the
desired feature. The siren will chirp with each press. The fea-
ture can now be changed using the remote control.
6. Feature change - Press on the transmitter. If the sys-
tem chirps once, the feature has just turned off; if the sys-
tem chips twice, the feature has just turned on. If the fea-
ture has more than two settings, continue pressing
on the transmitter to toggle through the settings.
To advance to the next feature in the same column, press
the same number of times as the desired feature within 60
seconds; to change a feature in a different column begin at
step 4 by entering the column number first and then the row
nnoottee:: If the factory preset PIN has been changed, the new PIN must
be entered.