Install properly, Level freezer, Remove sales labels – Whirlpool EV150N User Manual
Page 4: Plug it in, Level freezer remove sales labels
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
1. Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2 Pick a safe place, indoors, away from in
flammables such as gasoline.
3. Allow 3 Inches (7.5 cm] air space on top of freezer
for proper ventilation,
4. Allow at least an inch (2,5 cm] between the
freezer condenser, on the back of fhe unit, and
the wall.
5. Allow
'/2
inch (1.25 cm) on each side of the freezer
for ease of installation,
6. If the freezer is to be in a corner, you might want to
leave extra space on the hinge side so the door
can be opened wider
Level freezer...
so the door will stay open at any position.
1. Keep the 4 bolts that hold refrigerator in shipping
crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator. Move refrigerator
into place.
3. Adjust each leg until the refrigerator won't rock.
4. Adjust front legs to level the refrigerator
- To raise corners, turn legs in direction shown,
- To lower corners, turn legs in direction shown.
5. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
Inside labels before using the freezer.
To remove any remaining glue:
1, Rub briskly with thumb to make a ball, then
remove,
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
surface finish.
NOTE: DO NOT REMOVE the Tech Sheet fas
tened under the freezer at the front.
Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer
Power Plug
3-prong
grounding plug
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re
quired. It is recommended that a separate circuit
serving oniy this appliance be provided. Use a
receptacle which cannot be turned oft with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.