Changing the light bulb, Removing the bottom trivet, To remove – Whirlpool EV150N User Manual
Page 6: To replace, The key eject lock, The signal light, To replace burned out signal light
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing the light bulb...
Light Shield.
WARNING: To avoid possible shocks, first unplug
freezer or turn oft electricity leading
to freezer at the main power supply.
1. Remove the light shield from the side of the control
panel. Depress the back of the shield to release the
tabs, then pull away.
2. Replace bulb with a 40-watt appliance bulb.
3. Replace the light shield. Insert the shield tabs in the
slots, then press the shield to snap into place.
4. Plug in power cord or switch on electricity.
Removing the bottom trivet...
To remove:
1, Lift front of trivet out of supports
2, Pull out.
To replace:
1. Position back of trivet on the rear wall supports.
2. Lower front into place
Lift the Front,
Then Pull Out.
The key eject lock...
can help reduce the hazard of child
entrapment.
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal I ight is not glowing, immediately check:
' for power interruption,
' for an unplugged power cord,
for a burned out signal light.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com
plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light:
1. Unplug power cord from outlet.
2. Open the freezer door.
3. Unplug burned out light and replace with one of
same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer.
Part No. 1103680
4. Close freezer door and plug power cord into outlet.