Chicago Electric 10" Compound Miter Saw with Laser Guide 69683 - Manual (Page 7)

Page 7 For technical questions, please call 1-800-444-3353. Item 69683
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly
1. Insert the ends of the Table Extensions into
the holes in the sides of the Base. Tighten the
Wing Screws to hold the Extensions in place.
The upper edge of the Extensions will be level
with the surface of the saw. This provides a
wider base for the work material to rest on.
2. Thread the Miter Knob into the end of the table
above the Miter Lock until securely in place.
3. Slip the Dust Collection Bag over the
Dust Outlet behind the saw.
Mounting
Use the four bolt holes provided in the Base to mount the Miter Saw to a
stable support before use. Mounting hardware not included.
SAFETY
OPERA
TION
MAINTENANCE
SETUP