Whirlpool ET25PK - Manual (Page 10)

U S I N G Y O U R R E F R I G E R A T O R
Removing the crispers and crisper cover
To remove the crispers:
1. Slide the crisper straight out to the stop.
2. Lift the front.
3. Slide out the rest of the way.
4. Replace in reverse order.
Pull out to the stop,
lift the front
and pull again.
To remove the cover:
1. Push up glass insert from the bottom, then
slide it out with both hands.
2. L'rft front of cover frame.
3. Pull cover frame up and out.
4. Remove metal cover support.
To replace the cover:
1. Replace metal cover support on wall supports
in front section of cabinet.
2. Fit back corner of cover frame into notch
supports on walls of refrigerator, then lower
front onto metal cover support.
3. Slide back of glass insert into cover frame.
Then lower front to level position.
Remove the
giase insert
Lift front of
cover frame,
then the back.
Adjusting the crisper humidity control
You can control the amount of humidity in the
moisture-sealed crispers.
• The control can be adjusted to any setting
between LOW and HIGH.
• LOW (open) lets moist air out of the crisper for
best storage of fruits and vegetables with skins.
• HIGH (closed) keeps moist air in the crisper for
best storage of fresh, leafy vegetables.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
10