Install properiy, Level freezer, Remove sales labels – Whirlpool EV150E User Manual

Page 4: Plug it in

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Install properiy...

1. Check the strength of the floor. It should hold the

weight of a fully loaded freezer,

2 Pick a safe place, Indoors, away from In­

flammables such as gasoline.

3, Allow 3 inohes [7,5 cm) air space on top of freezer

for proper ventilation,

4, Allow at least an inch (2,5 cm) between the

freezer condenser, on the back of the unit, and
the wall,

5, Allow

'/2

inch (1.25 cm) on eaoh side otthe freezer

for ease of installation.

6, If the freezer is to be against a wall, you might

want to leave extra space on the hinge side so the
door can be opened wider.

Level freezer...

so the door will stay

open at any position.

Levelling Leg

Lower

Raise

Start adjustment with the door hinge side.

1. Slide freezer into place.

2. Adjust front legs to level the freezer,

- To raise front, turn each leg clockwise,
-To lower front, turn eaoh leg oounter-clockwise.

3. Check with level.
4. After freezer is fully loaded, recheck with level.

Remove sales labels...

Remove the Consumer Buy Guide label and any

Inside labels before using the freezer.
To remove any remaining glue:

1. Rub briskly with thumb to make a ball, then

remove.

OR

2. Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1.

DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car­

bon tetrachloride, etc. These can damage the
material.

NOTE: DO NOT REMOVE the Tech Sheet fas­

tened under the freezer at the front.

Plug it in...

3-prong grounding

type wall receptacle

Retaining Clip

Freezer

Power Plug

3-prong

grounding plug

Recommended Grounding Method

A115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit

serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.

Attach retaining clip over power cord plug

from literature package inside the freezer.

Advertising