Using your freezer, Setting the temperature control, The power saving control – Whirlpool EV150E User Manual

Page 5: Removing the bottom trivet, Adjusting the temperature control, Cooling freezer first, The key eject lock, Energy saving tips

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using your freezer

Setting the temperature control...

To start, turn control to the middle of the dial. This

setting is designed to maintain the temperature at
or near 0°F(-17.8 °C) under normal operating
conditions.

The Power Saving Control...

POWER SAVING CONTROL

J

«g

.

REDUCES

POWER

%

^

EXTERIOR

OFF

ON

MOISTURE

Removing the bottom trivet...

1

Lift the Front,

Then Pull Out.

Adjusting the temperature control..

1. Turn control to higher number for colder temper­

atures,

2. Turn to lower number for less cold temperatures.

Cooling freezer first...

1. Allow freezer to cool 6 to 8 hours before filling with

frozen food.

2. Let it cool overnight before adding large amount

of unfrozen food.

Nofe: When freezer is first started, the compressor

will run constantly until the cabinet is cooled. It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door is opened.

After the cabinet is cooled, the compressor will

turn ON and OFF as needed to keep the freezer at
the proper temperature.

operates electric heaters. These heaters help pre­

vent moisture from forming on the outside of the
freezer when humidity is high,

1. Use the OFF setting when humidity is low.

2, Use the ON setting only if moisture forms on the

outside of the freezer.

To remove:

1. Lift front of trivet out of supports.

2. Pull out.

To replace:

1. Position back of trivet against back wall

of freezer.

2. Lower front into place,

The key eject lock...

can help reduce the hazard of child

entrapment.

To lock or unlock the freezer you must hold the

key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.

If the key is lost, contact your WFIIRLPOOL

dealer for a replacement. Always give the com­
plete model and serial number of your freezer

when requesting a replacement key.

Energy saving tips...

You can help your freezer use less electricity,

• Check door gasket and level freezer to assure a

good door seal.

• Clean the condenser coils regularly.
• Keep door openings to a minimum. Remove several

items at one time. Keep contents organized to elimi­
nate searching.

• Fill to capacity. Follow recommended procedures

for freezing foods. See pages 7 and 8.

• Set Temperature Control to provide temperatures

around 0°F (-17.8 °C], There is rx) need to store
toods below 0°F.

• Keep door locked to ensure door closure.
• Do not let frost build up to more than 'A inch (6 mm)

thick. Efficiency is reduced.

• Keep Power Saving Control on OFF when humidity is

low.

Advertising