Removable oven doors, Removal and replacement of oven, Warning – Whirlpool SBl3OPER User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Caring For Your Oven
Continued
4. Wash control knobs with warm, soapy water
and a sponge. Rinse well and dry with a soft
cloth. Do not soak.
5. Replace control knobs by pushing them firmly
into place.
NOTE: When cleaning, never use steel wool,
abrasives, or commercial oven cleaners which
may damage the finish. After cleaning, make sure
all control knobs point to OFF.
Removable oven doors
Removing the oven doors will help make it easier
to clean the ovens.
^WARNING
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the
ovens are cool before removing oven
doors.
Failure to do so can result in burns or
electrical shock.
1. Open a door to the first stop position.
2. Hold the door at both sides and lift it at the
same angle it is in.
3. To replace, fit the bottom corners of the door
over the ends of the hinges.
Push the door down evenly. The door will
close only when it is on the hinges correctly.
Removal and replacement of
oven
If the oven is removed after installation, you must
follow this procedure:
1. Shut off main gas supply valve to oven.
2. Remove mounting screws and remove unit
from cabinet.
3. Disconnect electrical supply cord.
4. Disconnect the oven from the main gas supply
line. Make sure you do Step 1 before discon
necting the gas supply from the oven.
5. When reinstalling the oven, follow the
directions given in the Installation Instructions.
12