Thermostat calibrations, Shipboard operation, Unpack – Whirlpool 50 User Manual

Page 2: Figure 3, Changing the bin door and lower panel, General information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Changing the bin door
and lower panel

The storage bin door is designed to accept an optional
decorative wood panel of your choice.

The wood panel should be no more than 'A inch (6 mm)
thick. Cut it to the same size as the production metal

panel. See Figure 1.

To change the bin door panel:

1. Open the bin door.

2. Remove the two screws on top of the door which

hold the handle.

3. Remove the handle.

4. Slide the metal panel out.

5. Break off the ribs on the door insulation to allow for

the wood thickness. See Figure 2.

6. Slide the wood panel into the door frame.

7. Replace handle and screws.

To change the lower panel:

1. Remove the two screws at the bottom that hold the

lower panel assembly to the ice maker.

2. Remove the two screws on the top of the panel

assembly.

3. Slide the metal panels and spacers out.

4. Slide the wood panel into the door frame.

5. Replace the top of the panel assembly.

NOTE: Make sure the galvanized panel is replaced in
back of the panel assembly.

DOOR LOWER

BIN PANEL

WOOD

PANEL
DIMENSIONS

17”-

REMOVE ALL DOOR INSULATION
RIBS TO ACCEPT WOOD PANEL
THICKNESS

FIGURE 2

Thermostat calibrations

If ice maker is installed above two thousand feet of

altitude, the bin and evaporator thermostats must be
adjusted to a warmer setting. Disconnect electricity,
remove thermostat and follow the directions for turn­
ing the altitude adjustment screw as shown in the label
on each thermostat.

Shipboard operation

When this ice cube maker is installed aboard a ship,

it will be necessary to purchase and install a water
deflector. This deflector hangs between the lower edge
of the evaporator and the cutter grid. It keeps the water
flowing

over

the

evaporator

from

spilling

into

the

storage bin area. Order the necessary parts from your

local ice maker dealer.

General information

Unpack

FIGURE 3

FIGURE 4

FIGURE 1

1. Lay carton on rear face and break open bottom flap.

2. Set carton upright with all four flaps outward. See

Figure 3.

3. Lift carton up and off of machine.

Advertising