Cleaning and sanitizing the ice making system – Whirlpool EHC511 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING AND SANITIZING THE ICE MAKING SYSTEM

ice making system:

mh

; rninerals rejected from the circulating water

ciu'ing trie freezing cycle wili eventually form a
fiard icaiy deposit in the water system which pre­
vie.us a rapid release of the ice.

tdean ice and water system periodically to remove

ai ieia. .-.caia build-up. Frequency of cleaning

depends on water hardness. With soft water, clean­

ing ['■ dv not be required for several years. With
ruard A-ater (15 to 20 grains/gal.) cleaning may be
rcouifen as frequently as every six months.

ÌO cioan and sanitize, fohow this procedure.*

‘.ccapted by the National Sanitation Foundation,

t •■’hi. i c v le or service switch in "OFF" position

Riun sve the two thumb screws and slide the ice

tier qr d out of the two slots near the water pan.

i.d cl -c thie electrical harness.

cv

<-t

on

the grid should be melted underrunning

anr ,/\ater Attempting to pick the ice slab off

e q--id rncy stretch and damage grid wires.

ri,’ii. '-'tj all ice from the storage bin and the

n n / c K j o i a t n

: I the water pan by removing the drain plug

.[ii.i : b] and then replace the plug.

WARNING:

Most ice machine cleaners are citric or phosphoric

acid which can cause irritation even after dilution. In case of

contact with eyes, flush eyes thoroughly with fresh water and

contact a physician immediately. In case of contact with skin,

rinse well with water. If

swallowed,

give large amounts of water

and contact a physician immediately. Do not induce vomiting

KEEP OUT OF REACH OF CHILDREN.

6. Pour Vi gallon (1.9 L) of hot tap water into the
water pan and turn the service or cycle switch to
"CLEAN.” This warms up the system to make the
cleaning solution more effective. Let circulate for
five minutes. While tap water is circulating, prepare
cleaning solution. Mix:

6 oz. (170g) powdered citric, or phosphoric
acid into
Vi gallon (1.9 L) hot water

(Citric and phosphoric acid crystals are available

from many pharmacies or scientific supply houses.)

Commercial Ice Machine cleaners (liquid) are also
available from your dealer or refrigeration parts

supply stores. Mix according to instructions on

label (total quantity Vi gallon [1.9 L] ).

7. Turn Service or Cycle switch to "OFF" and
drain tap water, (See step 5.)

8. Turn the switch to "CLEAN" and slowly pour
the hot cleaning solution into the water pan. (If

the

solution

foams

while

pouring,

wait

until

foaming stops.) Then add the balance of the
solution.

Allow solution to circulate until the scale has
dissolved (15 to 30 minutes). Severe scale build-up
may require repeated cleaning with a fresh quantity
of cleaning solution.

To clean scale off the side flanges of the freezing

plate, use rubber gloves and scrub with a plastic

scrubby or non soap filled stainless steel pad dipped

in cleaning solution.

9. Drain the cleaning solution. Using the rubber
gloves, remove the drain plug and set the switch to

"OFF."

10.

Replace the plug and add Vi gallon (1.9 L) of

fresh water. Set switch to clean, circulate five

minutes, drain. Repeat rinsing process.

Advertising