Whirlpool EV190N - Manual (Page 4)

Before using your freezer
1. Clean it...
Clean your freezer before using it. See cieoning
instructions on page 7.
2. Remove sales labels...
Remove the Consumer Buy Guide iobel and any
inside iobeis before using the freezer.
To remove any remaining giue:
1. Rub briskly with thumb to moke o boii, then
remove.
OR
2. Soak area with dishwashing detergent solution
(1 teaspoon detergent in 1 quart warm water) be­
fore removing giue as described in step 1.
DO NOT USE rubbing aicohoi or fiammabie or
toxic soivents, such as acetone, gasoiine, car­
bon tetrachioride, etc. These can damage the
surtace tinish.
NOTE: DO NOT REMOVE the Tech Sheet fas­
tened under the freezer at the front.
3. Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer
Power Plug 3-prong
grounding plug
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.
4. Install properly...
1. Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Allow 3 inches (7.5 cm) air space on fop of
freezer for proper ventilation.
3. Allow at least an inch (2.5 cm) between the
freezer condenser, on the back of the unit, and
the wall.
4. Allowy 2 inch (1.25 cm) on each side of the freezer
for ease of installation.
5. If the freezer is to be in a corner, you might want
to leave extra space on the hinge side so the
door can be opened wider.
5. Level freezer...
so the door will stay open at any position.
This freezer has 2 threaded leveling legs that are
shipped in a separate package.
1. Screw these legs all the way into bolt holes in the
bottom front corners of the freezer.
2. Slide the freezer info place.
3. Adjust front legs to level the freezer.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
4. Check with level.
5. After freezer is fully loaded, recheck with level.