Install properly, Level freezer, Remove sales labels – Whirlpool EV15HK User Manual

Page 4: Plug it in, Install properly level freezer remove sales labels

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Install properly...

' Check the strength of the floor It should hold the

weight of a fully loaded freezer.

2 Pick

a safe place, indoors, away from in­

flammables such as gasoline.

3, Allow 3 inchet (7 5 cml airspace on top of freezer

for proper ventiiahon

4 Allow' of lecrt an 'Och [2 5 cm] oefw-een the

freezer cond'-nser, on the back of the unit, and
the wal

b Allowt, inch 2 25 cm] on each side ct the freezer

for ease of in'.’allation

6. If the freezer i; "o be in a corner, you might want to

leave extra syoce on the hinge side so the door

can be opened wider.

’ The four Dolts mat held your freezer in the shipping

crate ore designed to be the levelling legs. Screw
the legs far erough into the bolt holes, in each of

the four bottr.mn corners, so the freezer stands
about ■ mch , . ' 5 cm] off the floor

Level freezer...

so the door will stay open at any position

This freeze: has 2 threaded leveling legs that are

shipped in a separate package.

Remove sales labels...

Remove the Consumer Buy Guide label and any

inside labels before using the freezer.

To remove any remaining glue:

1, Rub briskly with thumb to make a ball, then

remove

OR

2, Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1

DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the

surface finish.

NOTE: DO NOT REMOVE the Tech Sheet fas­

tened under the freezer at the front.

Plug it in...

Screw these legs all the way into bolt holes in the
bottom front corners of the freezer.
Slide the freezer into place.
Adjust fropr legs to level the freezer

- To raise front, turn legs clockwise
- To lower front, turn legs counterclockwise.
Check with level
After freezer is fully loaded, recheck with level

Recommended Grounding Method

A115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded eleotrioal supply Is re­
quired. It is recommended that a separate circuit

serving only this appliance be provided. Use a
receptacle which cannot be turned otf with a

switch or pull chain. Do not use an extension
cord.

Attach retaining clip over power cord plug

from literature package inside the freezer.

Advertising