Features and operation explained — front of radio – C. Crane CCRadio SW User Manual
Page 10
Page 10
CCRadio SW
Features and Operation Explained — Front of Radio
CLOCK SET
Y
The
button has two functions:
1) When the radio is “off”, the
button sets the time on the default clock.
CLOCK SET
See “DUAL TIME”
(page 8) to set “WORLD” or “LOCAL” time clock to the default
time clock.
To set the time, press and hold the “CLOCK SET” button
Y
until the Hour begins to flash.
While the Hour is flashing use the “HOUR ” button
T
or “TUNING” dial knob
q
to set
the hour. Then press the “MINUTE ” button
R
to select the minutes. The Minutes will
flash on the display. While the Minutes are flashing use the “MINUTE ” button or the
“TUNING” dial to set the minutes. To complete setting the time, you must press the
“CLOCK SET” button while the time is flashing. If you donʼt press “CLOCK SET” while the
time is flashing, the time will change back to the time you started with and you will have to
start over.
NOTE:
Pressing the “HOUR ” or “MINUTE ” buttons will increase the numbers only. Using
the “TUNING” dial will allow you to increase and decrease the numbers with the change of
direction of the dial.
CLOCK TIPS:
You can also use the “TUNING” dial after pressing “HOUR” or “MINUTE”. Read
“DUAL TIME”
(page 8) to use the clocks the way you prefer. See also the “HOUR ”
button (page 10) to change the hour to 12/24 hour format.
NOTE:
Setting the “LOCAL” time clock also sets the “WORLD” time clock. Next to the
“WORLD” clock you will see Time DIFF and a number displayed. If you set the “WORLD” time
<
<
<
<
<
<
1) It will increase the frequency one step at a time with each press and release of the
button.
2) It will automatically search “up” in frequency until it finds a relatively strong station to
stop on, when you press and hold the button for two seconds.
3) When used with “MEMSET” button
Y
it toggles memory number positions for storing
stations to memory. See “MEMORY SET” (page 11) to set stations to memory.
When the radio is “off”:
4) It is used with “CLOCK SET” on button
Y
to set the hours for the clocks and timers.
See “CLOCK SET” (below) and “ALARM SET” (page 12) to set clock and alarm times.
5) Press and hold the “HOUR ” button
T
for five seconds to toggle the clock time on
the display between 12 or 24 hour modes. “AM” and “PM” indicators will be displayed
when the clock is set to 12 hour mode.
Note:
This sets both “LOCAL” and “WORLD” time clocks to the same hour format.
<